The carpet on the other hand has been re-done 3 times but never seemed to look quite right. Whether it was the grain of the carpet not being straight in the cab, or the carpet being cut down the middle and then installed around the seats, rather than under the seats due mostly to the large base of the custom seat brackets..
During the last carpet installation, the seats were removed, the large seat bracket bases were trimmed down, and the carpet was laid across the full length of the cab floor.. Everything looked good until I noticed a 6" cut just behind the gas pedal (to allow installation over the pedal) that didn't look right.. I had specifically asked that the gas pedal be removed so that no cuts to the carpet would be needed for a clean install.. Now the cut had been made in the new carpet and the frayed edges from the cut (even as minor as they were) were standing out like crazy to me.. I just knew that eventually the edge would would wear into a hole. Also the carpet still wasn't stretched because the outside edges hadn't been secured with fasteners yet.. And in fact the fasteners weren't ready or wrapped in leather yet. And the Lindon Days car show was the very next day.
I had high hopes the truck would be ready for the car show that weekend, but the progress and the results just weren't there. So we decided to skip the car show and I wrapped up any futher efforts being made on the truck by Monty. I settled what I owed him and decided to work with another upholsterer (Candido Escobedo - All In One Upholstery) who Joe had recently met. After talking to Candido, he put me at ease with the number of great ideas he had to help finish up the carpet and the headliner edging. Also he said he would have it done in a week! I was grinning ear to ear!
Soon after the truck was delivered to the upholstery shop, Candido was able to get a role of the new carpet and set out to install it.. Soon after he mentioned that it was pretty thin carpet and not the best quality we could use on the truck.. Candido had a scrap of carpet that came out of a car that Kirkham automotive used in one of their Cobras... The color was really close to the shade of the leather in the truck, and it was also about 3x more plush than the carpet we were using.. The material was made from wool rather than nylon also which gives it a more fluffy appearance which looked and felt great. Overall I was really drawn to the new carpet and asked if there was any possibility of obtaining this carpet for the truck.. Candido said he would check.
Then Candido showed me his plans to cover the edges of the speaker box with leather to hide the carpet binding edges which are visible with the doors open. Overall I liked what I was seeing.
The next day Candido called and said.. Guess what my man? We were able to get 4 yards of carpet for your truck! I was thrilled! So he returned the other carpet and proceeded to install the new carpet in its place. He also worked with Joe to modify the side of the seat panels a bit more to have them roll behind the seat back (see above) rather than extend further back. Great attention to detail.
Here is how the carpet was fastened to the inner step of the cab.. Leather trim which looks great. Also notice that he added more padding beneath the seat base under the carpet to eliminate the humps from the cross member supports below the cab floor. This really smoothed out the appearance of the cab floor.
Unfortunately (or not) with only 4 yards of carpet, we didn't have enough material for Candido to re-cover the speaker box, so instead we covered it in leather! I've never seen a leather subwoofer box, but boy does it ever look cool now! :-)
Candido also dished out the arm rest pull pocket a bit more and reinforced it with stitching. The previous arm rests looked very cool stylewise, but were hard to grip onto when shutting the doors. The new handles are much deeper and easier to grasp onto.
Here is how the arm rest looks now with the new deep pockets. No change to style, just more functional.
Unfortunately not everything goes as planned.. During the installation of the seats the bolt holes didn't line up just perfectly and Candido had to re-drill one of the holes.. That particular location where the new hole was to be drilled was directly above our transmission cooler.. and as you can now see, the cab floor as well as the transmission cooler radiator was drilled through which spilled all of the trucks transmission fluid onto the floor of Candido's shop.
Luckily Joe and Eric Horvath have connections.. They were able to get Tanner Radiators in American Fork to patch the radiator on the transmission cooler which saved me ~$300 for a new radiator and allowed us to fix the truck the same day.
Meanwhile, since Thunderpig was un-driveable, the truck had its first ride on a nice flatbed from Candido's upholstery shop over to Joe's.
I was so nervous that the truck was going to go rolling off into Joe's paint booth.. But luckily that didn't happen.
Once the truck was on the ground, Candido opened the door and showed me that he had wrapped the steering wheel in the same color leather as the rest of the interior as a way of saying, sorry I drilled through your transmission cooler.. ;-) I was very impressed. Not only was this a genuine way of showing he cared, but it also looks awesome.
I was really excited to see the interior finished so quickly and with such good workmanship. I'll post better pictures from tomorrow's car show.. There wasn't enough light in the shop to take decent pictures.. Let me tell you what.. The upholstery looks great! And its all in thanks to both upholsterers for a job well done! Thanks!
No comments:
Post a Comment