Sunday, April 25, 2010

Inner Bed Tubs

The past few months or so I've been searching the net trying to find a good set of inner wheel tubs for the truck.. The problem is that almost all of the wheel tubs you find online are made of two pieces and are pretty boxy looking.. We really wanted something more rounded out.. Well Joe came up with the perfect solution..

He had an old '61 Ford pickup in his lot with bed tubs that were exactly what we were looking for!

Joe cut out the tubs, media blasted them and then had them cut to the dimensions we needed.. I think they'll look great!

Dad helping cut out one of the fenders to make room for the new tub.

Joe mounting the new tire and checking to make sure we have the 2" clearance at the rear of the tire...

We have plenty of clearance now!

Attaching the tub and fender

Wow.. check out how huge the tire is compared to the old one.. lol!

2" clearance from the outside fender to the tire as well.. perfect! The back tires used to rub all the time on those fenders.. Not any more!

Sunday, April 18, 2010

Recent Truck Updates

Its been a few months since I last posted.. The truck is still at Horvath Hotrods.. They've been working on the fuel system and wiring for us.. On Monday they should get the steering column parts and brake/accelerator components. I'll do my best to get some pictures on here..

Here we are looking under the truck.. making sure everything looks right.

Sarah and her husband Nick were able to drop by the shop with us to check out the truck.

Fuel lines look good.. Nick and Sarah both gave a collective nod of approval..

Lots of loose wires inside the cab.. Trying to figure out where everything will run and to make sure we have all of the wires needed to power everything.

As for whats up next.. In a few weeks we should have a new custom built radiator coming in from Be Cool.. It's supposed to be able to cool up to a 700HP engine which is plenty of cooling power for us. Here are some pics of what it will look like.. This is for a Ford set up, but ours should have a very similar setup with the same dual fans & brackets.. On our radiator, the inputs/outputs (the tubes shown with the red tape) will be on opposite sides of the tank and it will be polished.. We can't wait to receive and install it!



Also, the AC (Vintage Air) has been ordered and should be here the following week. I'm a bit worried about putting in AC in the truck as it didn't originally have AC and requires some "fitting" as I've been told. We'll see.


I've also purchased new oak wood and trim for the bed and a sweet billet style dash assembly with Autometer gauges.. The dash assembly and gauges are the same as below.



The next few weeks are gonna be fun!